This is a SPECIAL modified INOVA equipped with a rainbow LED bulb that will light up RED then GREEN and then BLUE every four seconds! You've never seen anything like it. This will not flash through the different colors randomly like our RAINBOW INOVA, rather, it will display for four seconds each RGB color and then after the first cycle, it starts to pair off two colors at the same time so that you get yellows, purples, and even aqua! Note: Due to modification, dot mode and signal mode will not work. This is strictly for high power mode usage.

This is an OrbitLightShow.com favorite! Especially when in an ORBIT!

• 6 Colors in 1: Red, Green, and Blue (plus Cyan, Magenta, and Yellow! alternating, color changing, & strobe-like effect)

How do you get so many colors from this INOVA?
Tri-color / Rainbow / RGB modified INOVA lights only emit Red, Green, & Blue (RGB) but how is it that in my videos you see purple, yellows, & oranges? The concept is actually quite simple, when one or two colors mix, they produce other colors; Here are some images to help understand the concept better...


So, when the tri-color keychain lights are spinning rapidly and changing between the RGB values, they mix producing purples, oranges, yellows! =)

Product Highlights

One Function:

o High power

- Temperature Operation Range from -20° to +40°C
- Easy-Open/Snap-Shut Construction for effortless battery replacement
- Durable Stainless-Steel Universal Clip
- Limited Lifetime Warranty USA

TO ACTIVATE YOUR MICROLIGHT FOR THE FIRST TIME:

Press and hold down the button for 15 seconds until the light goes out.

OPERATION GUIDE

Press the button one time for high power
Press the button two times for low power
Press the button three times for strobe

If you leave your Microlight on any setting for more than 2 seconds the next press of the button will turn it off and not go to the next function.

In the high power setting your Microlight will automatically shut off after 4 minutes. Low power and strobe settings will run as long as they are active.

To reset your Microlight into signal mode:
Press the button three times for strobe mode.
While the light is strobing, press and hold the button for 5 seconds.
In signal mode your light will only work as a squeeze light.

To activate normal operating modes press and hold down the button for 15 seconds until the light goes out.